Condition: OEM

The video above is a guideline about how to take apart the Motorola Backflip

Step one: Remove the backfilp battery door and battery

Step two: Remove the backflip back housing.

First remove the 5 screws on the back housing and then separate it with a tool.

Step three: now it is time to remove the backflip motherboard.

To finish this, first please lift the foil that covers the flex cable, then disconnect the two flex cables on the motherboard. After that, take off the backflip vibrator and camera away. However, the motherboard cannot be removed now There is still a flex cable ribbon that needs to be disconnected.

Step four: remove the Backflip C side housing.

Before doing that, please take off the speaker and the antenna first. Now use a screwdriver to push one end of the hinge off the C side housing, then pull the hinge out from the other side.

Step five: remove the Backflip digitizer touch screen.

First Remove all the screws on the Backflip B side housing. Then use a tool to separate the digitizer. And disconnect the Backflip digitizer flex cable.

Step six: seperate the Backflip LCD screen.

First disconnect the hinge flex cable. Then take the upper keyboard cover away. Now use a knife to lift the Backflip LCD and the LCD board, and disconnect the LCD flex cable.
Now the Motorola Backflip is completely taken apart.